Mavix MediaRacer 100 Manuel d'utilisateur télécharger pdf (Page 25)

---MAVIX---

MediaRacer® 100 [Preliminary] 25

CONNECTION TO NETWORK

Connect one end of a communication cable (CAT5 direct cable) to the 10/100 connector

on the front panel of the MediaRacer® 100 unit. Connect the other end of the

communication cable to your local Ethernet network (SWITCH/HUB). Verify that the

LNK LED is lit.

CONNECTING DEVICES

CONNECTING VIDEO SOURCES

1. One video source may be attached to the MediaRacer® 100.

In order to attach a video source, connect one end of a video

coax 75 Ω cable to the video output of the Camera. Connect

the other end of the cable to one of the VIDEO IN

connector, located on the unit front panel. The lit LED

indicates the camera that has been selected from the attached

cameras.

Note: Pay attention to maximum coax cable length as

defined in the Specifications section.

Comment

???

?????

????"?"????"?????

connector???socket

"??????????????????'?

??????"????'?????????

?????????????connector

?????????????"?connector

"??socket"

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 72 73

Pas de commentaire

Mavix MediaRacer 100 Manuel d'utilisateur Page 25